sizing forms(pdf)

Model Sizing From for the RollerDrive

Please send each inquiry or question by completing the following.
Privacy Policy
Your information
Company name [mandatory]
Department, Position
Your name [mandatory]
Email address [mandatory]
* Confirm by entering the same email address again.
Phone number [mandatory] (Numbers only)
Fax number (Numbers only)
Address[mandatory]
Please enter the information necessary for making a model selection.
Application
Provide sketch and indicate loads to be mounted or applied to the output shaft
Table diameter：D1 [mm]
Table mass：W1 [kg]
PCD of fixtures：D2 [mm]
Mass per fixture：W2 [kg]
Number of fixtures：n2 [ pcs.]
PCD of workpieces：D3 [mm]
Mass per workpiece：W3 [kg]
Axial/radial load [ N ]
Moment load [ N ･m]
Number of workpieces：n3 [ pcs.]

Motion pattern
①Indexing period [deg]
②Acceleration time [sec]
③Constant speed time [sec]
④Deceleration time [sec]
⑤Dwell time [sec]
⑥Cycle Time [sec]


Servo motor

Please write your questions below.
top